MetalliScanner® m40 solves the very difficult problem of finding studs in lath and plaster walls. It works by finding the pattern of nails that attach the wood lath to the studs. MetalliScanner® m40 finds plumbing, ductwork, rebar, nails, and screws in your walls, floors, and ceilings, and is great for scanning reclaimed lumber for hidden metal.

MetalliScanner® m40 has two scanning positions, each with a progressive LED display. As it approaches a metal object, the red LEDs progressively light from the bottom up. The top lighted blue coil and an audio tone indicate when a metal target is located.

• Use Pinpoint Scan to locate small metal objects such as screws and nails
• Use Wide Scan to detect metal in walls or concrete
• LED arrays indicate signal strength.

Zircon One Step
i520

MultiScanner® i520 OneStep® quickly and easily locates the edges and center of wood and metal studs and joists behind walls, floors, and ceilings. It also locates metal as well as live AC electrical wiring.

A 4-mode switch makes it easy to change functions, while the ultra-bright display screen, SpotLite® Pointing System, and audio tone all indicate the location of the target. The signal strength indicator helps to distinguish between shallow and deep targets.

• Stud Scan mode locates the edges and center of wood or metal studs up to 3/4 inch (19 mm) deep
• DeepScan® mode doubles the scanning depth to 1 1/2 inches (38 mm)
• An ultra-bright LCD screen indicates direction, edges and center of studs
• AC Scan finds and traces live, unshielded electrical wiring up to 2 inches deep
• Metal mode detects non-ferrous metal, such as copper pipes, up to 1 1/2 inches (38 mm) deep, and ferrous metal, such as rebar, up to 3 inches (76 mm) deep
• WireWarning® detection indicates the presence of live, unshielded electrical wire up to 2 inches (51 mm) deep in stud and metal scanning modes
• ACT™ (Auto Correcting Technology) automatically corrects common user errors, such as when scanning begins over a stud

MetalliScanner® MT 6 locates both ferrous and non-ferrous metal up to 150mm deep in concrete and other non-metallic surfaces. It also differentiates between ferrous and non-ferrous metal targets and indicates the target depth in inches and centimeters.

MT 6 indicates when you are approaching a metal object with a large plus (+) sign on the display. When the plus becomes a minus (-), you have crossed over the target and are now moving away.

Use MetalliScanner® MT 6 to find or avoid rebar, cables, pipe, nails in reclaimed wood, nails/tacks in studs behind lath & plaster walls, electrical boxes and conduit, and more.

• Automatically differentiates between magnetic metal (such as rebar) and non-magnetic metal (such as copper pipe)
• Shows the depth of metal from the surface in both inches and centimeters
• Easy-to-read LCD screen pinpoints the location of metal objects to the nearest inch and depth to the nearest 1/2 inch (13 mm)
• Helps map out the grid of metal through any nonmetallic construction material, including concrete, tile, and marble

• Detectable materials: Plastic, electrical cables, ferrous,
  non-ferrous metals, wood.
• Measuring depth: Up to 100 mm
• Accuracy: +/- 5 mm
• Automatic cutoff: Approx 5 min
• Power supply: 4x 1.5 V AA batteries
• Unit of measurement: cm
• Weight: Approx 800gms
• Length: 277 mm
• Width: 98 mm
• Height: 103 mm